Hallo liebe Community,
Habe versucht YAHM auf einer Berryboot Installation und auf einer Installation mit mehreren Partiotionen auf dem PiDrive zu installieren.
Bei beiden Varianten ist das Verhalten identisch:
Die Installation bricht ab:
Found ARM based distribution
Disable new dhcpcd on Raspbian Jessie
Synchronizing state for dhcpcd.service with sysvinit using update-rc.d...
Executing /usr/sbin/update-rc.d dhcpcd defaults
Executing /usr/sbin/update-rc.d dhcpcd disable
insserv: warning: current start runlevel(s) (empty) of script `dhcpcd' overrides LSB defaults (2 3 4 5).
insserv: warning: current stop runlevel(s) (0 1 2 3 4 5 6) of script `dhcpcd' overrides LSB defaults (0 1 6).
Updating sources
Installing dependencies
install sendmail
Die E-Mail-Oberfläche benötigt ein installiertes »sendmail«, verwende Pager
bash-completion is installed
wget is installed
install dos2unix
python is installed
install git
install lxc
install liblzo2-dev
install bridge-utils
install python-lzo
patch is installed
gzip is installed
openssl is installed
Clean up YAHM directory (removing old versions)
done
Downloading actual version from git repository
Including YAHM into PATH
Installing bash command completion
Done
Enter quick install mode
Installing LXC container
YAHM LXC container was installed successfully
Creating Bridge for networking
Bridge yahmbr0 with interface eth0 was created
Attaching network configuration to LXC container
An error occurred while processing quickinstall mode. Pleasy try manually installation
Versuche ich dann die manuelle Installation erhalte ich folgende Fehler:
sudo yahm-lxc install
ERROR: We dont have any patches for this version, please call 'yahm-ctl update' and try again
Installation auf Pi3 mit WD PiDrive klappt nicht
Moderator: Co-Administratoren
Re: Installation auf Pi3 mit WD PiDrive klappt nicht
wechsle auf den develop branch oder warte noch etwas bis aktuelle version in dem master aufgenommen wurde
Re: Installation auf Pi3 mit WD PiDrive klappt nicht
Vielen Dank leonsio! Hat geklappt.leonsio hat geschrieben:wechsle auf den develop branch oder warte noch etwas bis aktuelle version in dem master aufgenommen wurde
Wie bekomme ich mit, das die aktuelle Version in den master aufgenommen wurde?